Additionally, it is taller than most printers, it being specified at 360mm (most have over 370mm clearance).

Already from 80 mm/s onwards, the firmware apparently no longer keeps up with the calculation of the movements.Thin walls get a bit wider to the edges, because here the effects of the long Bowden extruder come into full play.

All three stepper motors start rotating simultaneously and as soon as a limit switch is reached, only the motor in question is stopped until all three limit switches are finally reached. In contrast to conventional printers, the limit switches of a Delta printer are located at the top of the frame. Marlin, on the other hand, has fewer problems and somewhat exceeds expectations in the practical test of printing speeds. This means they are far faster than the traditional, flatbed design of other manufacturers due to the lightweight moving parts. In addition, my daily breakfast is Notebookcheck's long list of new content, which I comb through to select the most interesting topics for translation from English to French, Italian, Spanish, Portuguese, and Dutch.If ABS is printed without a frame cover, the box begins to visibly detach from the print bed at a height of 10mm. The Voltcraft SL-10 sound level meter still shows a maximum volume of around 60 dBA even at a distance of one meter (~3.

I have found this from the flsun qqs facebook group that someone made, uploaded it to the SD, started duetwifi 192. However, the practical test with the original MKS firmware reveals considerable weaknesses here at higher printing speeds. Thus, especially at the beginning and at the end of the individual extrusions of the Anycubic PLA filament, you can see that it takes some time until a stable filament flow is achieved. The heavy stepper motor of the Bowden extruder is also located on top of the device and therefore does not have to be moved when printing. The rods are straight, the illusion of a bend in the photo is only created by the wide-angle lens of my camera.Can the extruder of QQ-S Pro be replaced with another type of extruder, such as BMG extruder, which parameters in the firmware need to be modified? You can recognise this printer because it has a power switch either to the rear of the device (where the power lead is) or to the front, right of the screen.

It has a flexible three-axis linkage system, a powerful 32-bit motherboard, a 24V power supply, a lattice hot bed, and an all-metal side shell to ensure better printing quality and a more stable structure. As soon as the distance from nozzle to print bed is correct, there are hardly any problems with PLA adhesion. I usually use the Prusa Slicer, and it’s a good thing Prusa recently added the Delta machines from FLSUN! Even though the 3D printer detects short circuits and missing thermistors, it does not shut down when there is no temperature change despite heating up. The test printout with Marlin in gray shows slightly less stringing and blobs than the one with the MKS firmware in white, but it should also be noted here that the temperatures from the hotend are apparently calculated differently by Marlin and the MKS Firmware.This manifests itself in jerks and later also in large holes in the walls, since the filament flow is not stable when the firmware repeatedly stops the movements of all motors briefly.