Corsair iCUE COMMANDER CORE XT, Digital Fan Speed and RGB Lighting Controller (Control up to Six PWM Case Fans and 264 RGB LEDs, Zero RPM Mode, Temperature Monitoring, Easy Installation) Black

Product Information

Q: What about my LED strips? Do I still need to use the iCUE Lighting Node Pro RGB Lighting Controller? On the 2nd USB Lighting Node I just have the 2 QL 140mm Fans lighting wires connected, because I have the Fans powered by the NZXT Z63 and I can control the RPM through NZXT CAM. https://help.corsair.com/hc/en-us/articles/360025166712-Perform-a-clean-reinstallation-of-the-Corsair-Utility-Engine-iCUE- Hey' can anyone help me with a issue I'm having which I noticed after replacing the first Faulty Fan. The updated, low-profile design makes installation easier with embedded magnets, making it easy to install the COMMANDER CORE XT on any flat surface inside your case

This is pretty odd. How do you have the CoCoreXT connected? And the CoCore? The ComCoreXT has a splitter on the USB Connector - is the Commander Core connected to that? So far, nothing at all works. I still have full control over the 6 intake fans and no control or recognition of the 4 exhaust fans. Finally, the LCD kit is connected to the CPU_FAN port of the mainboard, and all controllers/repeaters are connected to the power supply via the SATA power cable.

The WORST Trend In Gaming

All I have left is the adapter that will arrive today that will convert the internal USB connector to a traditional USB 2.0 male connector that I'll plug into the rear of the mobo. Configure 4-pin fan lighting using the setup wizard. You can choose to have the controller automatically detect fan type per port, or set up the fans manually. If I had your same configuration, I would mount the H150i ELITE CAPELLIX atop. Using its included COMMANDER CORE, I would then connect the H150i's three fans and three front fans. The remaining four fans would connect to the COMMANDER CORE XT. This is illustrated below. My reasoning behind having the front and top fans on the same controller is for iCUE's sequential lighting effect. The 4x QL120 RGB fan (No.7) is connected to the Lighting Node Core and the PWM Repeater of the iCUE 5000x RGB case.

On my setup I have 8 Fans total, now I only have 6 Fans directly to The Commander Pro and I have 2 Lighting Nodes connected to it. A: You do not. Similar to the Commander PRO, the COMMANDER CORE XT plugs into an available SATA power cable from your PSU and USB header on your motherboard.

Example - iCUE 5000x RGB withH150i Elite LCD (XT) and 4x QL120 RGB fans

Don't buy anything and connect the rear fan to a mobo's header. This won't allow you to control the rear fan through iCue. and why dont you try saying you have the fans you have in icue or pic the ones with the most RGB and the other will do the same but you wont have all the rgb on the fans itself? i mean lets just say that the LLs have 30 RGB LEDs for simplicity and the MLs have 15. you pic the LLs in icue as all your fans and all 30 LEDs of the LLs light up and the 15 on thje MLs Once your cooler is installed to your motherboard, it is time to connect the fans and pump to the iCUE Commander CORE.