If you’re curious why ATVs come with a thumb throttle instead of a twist throttle, you’ll find the answer in this post. Hand and Foot Brake So in that respect it doesn't matter how you turn the bike off, the ECU doesn't get unpowered abrubtly.

After selecting the gear range, the gearing is handled automatically by the transmission and clutches. On some bikes the unit does not get power when the engine is off. If you wish to program the unit with engine off, proceed as follows:

Make sure the label on the unit is “iQSE”. If you see “QSE” you have the first generation module and it’s not compatible with iOS devices. For active or high-speed riding, it’s good practice always to leave one or two fingers resting on the brake lever to reduce reaction time and stopping distance. The other fingers should maintain the grip around the handlebars at all times. Foot Brake Press the brake pedal down with your foot to apply the brakes.

The other end of the engine management relay coul is grounded so ECU is powered wnenever ignition and kill are conducting.

The essential controls of an ATV include the handlebars for steering, brake levers to stop, a throttle lever to control speed, and various switches for operating the lights, winch, and ignition system. This switch is installed on the battery, just like the wired version. With the use of magnets, the switch allows the use of the battery when you want to drive, and turns it off when you are protecting your car. However, you are going to run into the same memory issues that were found with the last battery option. Gear shifting controls on Semi-Automatic ATVs:ATVs with semi-automatic transmissions typically have a push-button style of gear-shifter. Push UP to switch to a higher gear, and press DOWN to switch to a lower gear.

In this guide, we cover the five types of automotive kill switches, so you can determine which is best for you. We also look at the total cost you can expect. What is an Automotive Kill Switch? The working range is affected by the module’s position and the phone’s Bluetooth capabilities. Many phones do 10m with the iQSE, others only do 1m. Move the unit to a different spot, farther from the ECU. The Bluetooth range can be limited also when the phone’s battery is low. PARKING LIGHTS ON: After starting the ATV, the switch will return to this position where only the parking lights and taillights are on. Make sure you do clutchless upshifts only during acceleration, i.e. at partial to full throttle, well above idle speed. However, the installation of this device is a little more complicated. If you aren’t familiar with your ignition system, you want to look at the diagram in your service manual. You must cut the right wire and you may also prefer soldering the connection for a better fit. 5. Fuse Box Kill SwitchThere are times the shifts are really smooth, at other times it’s rough, i.e. the shift feel is not consistent Here is a more detailed list of the types of kill switches you can install in your car: 1. Fuel System Relay Switch